setting up cakewalk by bandlab for backing tracks

Route all audio in the session to be streamed to the Master channel in Cakewalk. Set Sessionwire's HQ Audio Destination to Sessionwire Receive Plugin. Set Sessionwire's Talkback Microphone and Talkback Speaker exactly as you would any video conferencing software - in the above image, the input is a webcam microphone and the output is the system's default output (an audio interface in this instance).Įnsure Sessionwire's HQ Audio Source is set to Sessionwire Send Plugin. This workflow will allow the sending of audio from a Cakewalk project while simultaneously receiving remote HQ audio directly into a Cakewalk project. Sending and Receiving Audio within Cakewalk (To send audio to a peer and receive remote HQ audio in Cakewalk) No need to route incoming audio into Cakewalk. The Sessionwire HQ Audio Destination is set to the system audio output device - this way any audio streamed from the remote end of the call is sent straight out of the output device. Insert the Sessionwire Send plugin on the Master channel in the Cakewalk session.

Set Sessionwire's Talkback Microphone and Talkback Speaker exactly as you would any video conferencing software - in the above image, the input is a webcam microphone and the output is the system's default (an audio interface in this instance).Įnsure the HQ Audio Source is set to Sessionwire Send Plugin.Įnsure the HQ Audio Destination is the system's default output. Simply placing the Sessionwire Send plugin on the Master channel of a Cakewalk project will produce the same results as in the downloadable template. This workflow is the simplest way to get up and running with Cakewalk alongside Sessionwire.

Sending Audio from Cakewalk (To send audio from Cakewalk to a peer and listen to their remote audio) It is recommended that all recording be done on the performing side of the Sessionwire call - meaning one side needs to have a DAW open to record in, while the other simply monitors the performance through Sessionwire.Įach user may be using a different DAW or may/may not be using an audio interface - therefore, each user will need to reference the correct signal flow diagram for their particular DAW and setup.īelow are common setups when using Sessionwire alongside Cakewalk.

Setting up cakewalk by bandlab for backing tracks